Handling the Large
Tripod
Dolly
The tripod dolly is only suitable for flat surfaces!
Loosen the transport safety device
(1)
Fold out the carriage spokes to the limit stop
and push the transport safety device (1) back into the hole. The
tripod dolly now has the typical star shape.
Secure the position of the carriage spokes
by tightening the central control element (2) (star grip) until it is flush
with the central disk (3) on the upper side.
Extend the stand to the desired height
(minus -10 cm tripod dolly height)
Loosen the clamping lever (4)
and pull out the segments as required (see back for information table)
Place the tripod on the dolly,
it is recommended to place the tripod legs on the dolly one after the other and
secure them with the elastic band (5).
Make sure that the tripod legs are fully spread and
tighten the clamping lever on the tripod dolly again.
Fastening the tripod dolly:
To do this, press the star grip (6) from above until the support touches the ground. By
turning the star knob clockwise, the carriage spoke is lifted via a fine thread until the wheel can move freely. The
tripod and tripod dolly are now fixed in position.
Mounting your equipment on the tripod
Fine levelling is possible via the star grip (6)
.
Change of location - Driving with the tripod dolly
Retract the support: Turn the star knob counterclockwise to the limit stop. Now press the locking device (7)
downwards and at the same time pull the support (6) upwards to the limit stop.
Transport - Folding the tripod dolly
: In reverse order, disassemble the equipment and tripod and adjust the right
and left carriage spokes to the value of about 4 cm.
Now move the central control element (2) with a few counterclockwise turns until a clear resistance is felt and the
central disk (4) is positioned deep in the star grip. Now lift the tripod dolly slightly by the carrying handle until the
control element disengages.
The two carriage spokes should now be freely movable. Now just remove the transport safety device (1) from the
holder, fold in the carriage spokes and secure them. The tripod dolly is now ready for transport.
