12 in 1 Steam Cleaner Max
H008
Instructions for Use
Please read and retain these instructions for future reference
v001: 24/08/20
Page No. 14
How to use hand-held steamer
CAUTION
Make sure that the steam Cleaner is unplugged.
1.
Fill the water tank with water. Please refer to the “HOW TO USE THE STEAM CLEANER” section in this
manual.
Attach either the round nylon brush or the round copper brush as explained in the “How to assemble h
and held steam cleaner” section in this manual.
2.
Once the unit has been fully assembled and filled with water, plug in the power
cord into an earthed electrical outlet.
RED light – Power indicator will indicate when power is on.
GREEN light will turn on when the steam cleaner is ready for use.
When the ready-to-use indicator light turns green turn the power switch (O/I)
to the ON (I) position. The hand held steam cleaner will start emitting steam.
3.
Select one of the following steam regulator option:
1 – Low, 2 – Medium, 3 – High or 4 – Hot Spray.
You can change the steam regulator position and the steam output while
operating the steam cleaner.
To stop emitting steam, turn OFF the unit by turning the power switch (O/I) to the
OFF (O) position. If the power switch is turned prior to the Ready-to-Use light indicator turning green, water
from previous use will not be heated and will be forced out by present steam.
This may also happen if the Power Switch (O/I) was left in the ON (I) position after previous use and the unit
was disconnected by unplugging only.
Make sure to turn the unit off after each use and then disconnect from the electrical outlet so the unit is in
the OFF (O) position when used next time.
4.
Slowly pass over surfaces to be cleaned. Apply steam liberally. Keep a towel handy and wipe away any
excess water that may accumulate.
5.
When the hand held steam cleaner stops emitting steam, simply turn OFF and unplug the unit, refill the
water tank and continue cleaning.
