Bercomac BERCO 700843, Руководство пользователя, Страница: 16 / 32

Hook-up and un-hook accessory
14
Hooking-up the snowblower
A. Drive the vehicle toward the accessory and unite
them by raising the lift arms (item 1), do not raise the
accessory more than 0.25 inches from the ground.
B. Stop the vehicle, see the procedure for stopping the
vehicle in the operation section .
C. Put a wooden block under the subframe to prevent
accidental movement of the subframe.
D. Secure the accessory to the subframe with two pins
(item 2) and two lynch pins (item 3). Then remove
wooden block
E. Install the hydraulic hoses of the chute, see section
installation of the hydraulic hoses in the hook and un-
hook section of the accessory.
See the snowblower manual for other instructions to
finalize the hooking of the snowblower to the subframe.
Unhooking the snowblower
Refer to the hooking section of the snowblower, as the
unhooking is done in the same way as the hooking, but in
reverse order.
A. Begin by following the snowblower unhooking
instructions in the snowblower manual.
B. Make sure that the hydraulic hoses of the chute are
disconnected from the vehicle.
C. Place the snowblower about 0.25" from the ground.
D. Stop the vehicle, see the procedure for stopping the
vehicle in the operation section .
E. Put a wooden block under the subframe to prevent
accidental movement of the subframe.
F. Remove the two pins (item 2) and the two lynch pins
(item 3). Then remove wooden block
G. Lower the subframe to lower the snowblower to the
ground. Then back the vehicle to clear the
snowblower.