Bercomac 700980-1BER, Руководство пользователя

Страница: 20 / 48

Adjustments
18
Adjustments
Parking stand on the
snowblower
DANGER
To avoid serious injury or death :
Proceed to the assembly/adjustment on the accessory
after it has been properly attached to the vehicle and
secured with solid support. Never work around /under
equipment supported by hydraulics. Hydraulics can drop
equipment instantly if controls are actuated or if
hydraulic lines burst even when power to hydraulics is
shut off.
Lower the parking stand:
IMPORTANT : when in operation or when the
snowblower shaft is installed on the tractor, the parking
stand must always be raised.
Lower the parking stand allows easy hooking and
unhooking of the snowblower.
A. Raise the snowblower 2” f rom the ground.
B. Stop the vehicle, see the procedure for stopping the
vehicle in the operation section.
C. Remove the lock pin (item 1) then lower the parking
stand (item 2) and reinstall the lock pin at the
indicated place.
D. Lower the snowblower to the ground.
Raising the parking stand:
IMPORTANT : when in operation or when the
snowblower shaft is installed on the tractor, the parking
stand must always be raised.
E. Raise the snowblower 2” from the ground.
F. Stop the vehicle, see the procedure for stopping the
vehicle in the operation section.
G. Remove the lock pin (item 1) then raise the parking
stand (item 2) and reinstall the lock pin at the
indicated place.
H. Lower the snowblower to the ground.
Chute deflector
Adjust the angle of the deflector according to the
distance at which the snow is to be projected and to
prevent damage to the property. To change the deflector
angle, loosen both knobs (item 1), adjust the knobs to
the appropriate angle, and tighten both knobs firmly or
use the optional electric deflector assembly.