Bercomac 700980-1BER, Руководство пользователя

Страница: 13 / 48

Accessory Hook-up & Unhook
11
Accessory Hook-up & Unhook
Hooking-Up the accessory
DANGER
To avoid serious injury or death :
A Crushing Hazard exists when hooking-up equipment. Do
not allow anyone to stand between vehicle and the
accessory while moving in the direction of the accessory
or pulling away from accessory. Do not operate hydraulic
lift controls while someone is near the skid vehicle or
accessory.
DANGER
To avoid serious injury or death :
Always engage parking brake or set transmission in park,
shut tractor engine off and remove key before
dismounting from tractor or allowing anyone to hook-up
and unhook the implement
The lower 3-point arms of the 3-point hitch must be
stabilized to prevent side-to-side movement. (Please
consult your tractor’s manual for adjusting instructions).
Make sure the accessory is on a flat level surface
A. Remove top hitch accessory hardware, see figure for
more details (item 1)
B. Remove lower hitch accessory hardware, see figure
for more details (item 2)
C. If applicable, align driveline properly to avoid
interferences.
D. Slowly back tractor up to the accessory while using
the tractor’s 3 -point hydraulic control to align lower
3-point arm holes with accessory lower arm mount
location (item A).
E. Engage parking brake or set transmission in park, shut
tractor engine off and remove key before
dismounting from tractor or allowing anyone to hook-
up and unhook the implement
F. Connect lower arm to accessory. With lower arm
properly aligned:
Connect the hole in the lower arm to the hole in
the accessory using the pin (item 1) and the hair
pin (item 2).
G. Connect top link to accessory:
Connect the top link to the hole in the accessory
(item A) using the pin (item 3) and the hair pin
(item 4).
Drawbar
Top Link
Lower arm
Lift arm
Using 3 point quick hitch
The accessory is supplied with adapter sleeve for 3points
quick hitch. See part list for part identification.
Disengage the parking stand after installing the
accessory on the tractor
:
Remove the lock pin (item 1) then raise the parking stand
(item 2) and reinstall the lock pin at the indicated place.