Bercomac 700980-1BER, Руководство пользователя

Страница: 15 / 48

Accessory Hook-up & Unhook
13
ATTENTION: Over tightening is one of the greatest causes
for oil leaks.
Test the hydraulic controls in order to make sure that they
coordinate with the movement of the accessory. If they do
not match, reconnect the hoses in the right order.
Check interferences
Repeat the following step for all possible adjustments of the
accessory (see adjustment section) and all possible
movement of any part of the accessory who affect the
position of any part of the accessory relatively to the
tractor.
A. After doing the adjustment, validate that any part of
the accessory does not contact any part of the tractor
B. Slowly move the accessory up and down and validate
that any part of the accessory does not contact any part
of the tractor
C. If there is a contact,
•
limit the movement of the accessory or tractor or the
lifting device on the vehicle
•
If the contact is with an equipment that can be
removed remove it. Always follow the instruction from
your vehicle and any other accessory manufacturer to
make sure you can remove this equipment
Leveling the accessory
•
To level from side to side manually adjust one of the
two lower lift arms up or down to level the blade
from left to right
•
To level accessory from front to rear manually adjust
the top center link length
Un-hooking the accessory from 3pt
hitch
CAUTION
To avoid severe injury:
If the if the accessory is equipped with a parking stand,
always make sure the parking stand is securely attached
in position with hardware correctly installed. If not, the
accessory can fall.
Safely lower the accessory
A. Park vehicle on a solid and flat surface.
B. Lower the parking stand.
C. Lower the accessory until skid shoe are resting on
ground.
D. Relieve the pressure in the hydraulic lines and
disconnect the hoses.