Bercomac 700980-1BER, Руководство пользователя

Страница: 14 / 48

Accessory Hook-up & Unhook
12
Install the PTO drive shaft on the input shaft of
the tractor.
If this is the first time the snowblower and PTO are
installed on the tractor, make sure to follow the
validation of the PTO drive shaft have been made (see
section assembly and initial setup).
IMPORTANT : Make sure that the PTO driveshaft is
correctly inserted on the tractor PTO and locked in place
on the tractor PTO.
Connecting the hydraulic hoses
DANGER
To avoid serious injury or death:
•
Escaping hydraulic oil under pressure can have
sufficient force to penetrate skin, causing serious
personal injury. If injured by escaping fluid, obtain
medical treatment immediately.
•
Wear protective gloves and safety glasses or goggles
when working with hydraulic system.
•
Before disconnecting hydraulic line or performing
work, relieve all hydraulic pressure
•
Visually check for hydraulic leaks and broken, missing,
or malfunctioning parts and make necessary repairs
before applying pressure to the system. Do the same
validation after applying pressure to the system (use a
piece of cardboard not your hands to detect leaks).
Connect the flexible hoses (item 1) for the snowblower’s
chute rotation to the vehicle’s hydraulic system (item 2).
Read all important following information on this page
before proceeding to the installation of the hoses.
Purging hydraulic system
Hydraulic components on the accessory can contain air.
The air needs to be purged from component
A. Raise the accessory 6’’ off the ground
B. Activate the hydraulic control to cycle all possible
movement of the accessory several times until the
movement is stable.
IMPORTANT:
*It is the user / or the person who does the installation’s
responsibility to install the hoses in such a manner that
they do not come into contact with any mobile elements
of the vehicle (the wheels or the subframe), sharp edge,
hot surface in all operating conditions if not, this could
lead to damages.
IMPORTANT: If manipulating the hydraulic commands
do not create any movement, one hose from the
hydraulic lift system is interchanged with one hose for
the chute rotation.
NOTE: Use a coloured tie wrap (not supplied) to identify
the different hoses to simplify future installation.
IMPORTANT: Twists in the hydraulic hoses will wear
them out prematurely. If the quick couplers are not
well aligned, slightly loosen the fitting (item 3) in order
to rotate the female quick coupler (item 4).
Lubricate
the threads with hydraulic fluid and tighten the joint at
25 ft-lb.