Bercomac 700968-1-33V, Руководство пользователя

Страница: 15 / 60

Accessory Hook-up & Unhook
13
Accessory Hook-up & Unhook
Hooking-Up the accessory - Skid
steer quick attach style
DANGER
To avoid serious injury or death :
A Crushing Hazard exists when hooking-up equipment.
Do not allow anyone to stand between vehicle and the
equipment while hooking-up to implement. Do not
operate hydraulic controls while someone is near the
vehicle or implement.
WARNING
To avoid serious injury or death :
Make sure the skid steer style loader hitch is properly
attached to the quick attach frame. It must be secured
under the top angle bar and locking handles must be
locked down with locking pins extending fully through
the bottom slots. An improperly attached equipment can
come loose and fall.
A. Shutdown vehicle see “vehicle shutdown procedure”
in the operation section
B. Make sure all hooking components are clean and no
components will interfere with hitch hook-up. If
needed, pull locking handles up on loader hitch until
locking pins are fully raised.
C. Carefully drive up to the accessory making sure
loader hitch is parallel with the quick attach frame
(item A).
D. Rotate top of loader hitch slightly forward.
E. Place top of loader hitch under the top angled bars
(item B) on the quick attach frame.
F. Slowly lift loader hitch up until hitch and top angle
bars on the equipment have come together.
G. Rotate top of loader hitch back to align bottom slots
(item C) in the quick attach frame with locking pins
on the loader hitch.
H. Shut down vehicle before dismounting to complete
hook-
up. Refer to “ vehicle shutdown procedure” in
the operation section
I. Push locking handles on loader hitch down until
locking pins fully extend through bottom slots (items
C) in quick attach frame. Make sure locking handles
are locked into position to keep pins from backing
out
J. See hose Hook-up section and electrical Hook-up if
applicable
Note : Accessory has been hidden on the picture above
for comprehension purposes.
Check interferences
Repeat the following steps for all possible adjustments of
the accessory (see adjustment section) and all possible
movement of any part of the accessory which affect the
position of any part of the accessory relatively to the
tractor.
A. After doing the adjustment, validate that any part of
the accessory does not contact any part of the
tractor
B. Slowly move the accessory up and down and validate
that any part of the accessory does not come in
contact with any part of the tractor.