Bercomac 700580-4, Руководство пользователя

Страница: 25 / 100

22
MAINTENANCE
ENGINE MAINTENANCE
Maintain the engine according to the instructions in the
engine’s owner’s manual.
SNOWBLOWER MAINTENANCE
Check mounting bolts at frequent intervals for proper
tightness in order to prevent costly repairs. Make sure
your snowblower is in safe working condition.
PRESSURE OF THE TIRES ON THE
SUBFRAME
Verify and adjust the pressure on the tires of the
subframe at 50 psi.
The tire pressure must be even on both sides.
WARNING
Before proceeding with any snowblower
maintenance, assembling or dismounting:
Apply parking brakes of the vehicle.
Stop the snowblower engine and remove the
ignition key
Disconnect the wire from the spark plug(s) and
keep away from spark plug(s) to prevent
accidental starting.
CUTTING EDGE MAINTENANCE
Verify from time to time the wearing on the cutting
edge to make sure you do not wear out the base of
the snowblower’s chassis. This cutting edge is
reversible. Unscrew the bolts and turn the cutting
edge,
Reinstall with new carriage bolts 5/16’’ x 3/4’’ grade 5
and new lock nuts 5/16’’.
WARNING
If the snowblower is in the raised position,
always verify to provide adequate blocking
before working underneath the snowblower.
SNOWBLOWER PULLEY REPLACEMENT
OR ALIGNMENT
Clean the parts before aligning or replacing the pulley.
Apply some "Locktite" 2760 on the key and the set
screws. Tighten firmly.
WARNING
-
Do not attempt to clear clogged chute, auger or
fan of snow while the snowblower's engine is
running.
-
Disengage snowblower.
-
Lower snowblower onto ground.
-
Set the parking brake.
-
Stop engine, remove the ignition key, disconnect
the wire from spark plug(s) and keep away from
spark plug(s) to prevent accidental starting.
-
Make sure all moving parts have stopped.
-
Do not use hand to unclog chute, use the chute
shovel supplied with the snowblower.
CLEARING A CLOGGED CHUTE
Whether it is the snowblower auger, the fan or the
chute that is clogged, it is essential to follow these
instructions to the letter.
1. Disengage the electromagnetic clutch
2. Lower the snowblower to the ground and apply
the vehicle’s hand brake;
3. Stop the snowblower engine, remove the key and
wait for all the rotating parts to stop turning.
4. Disconnect the wire from the spark plug(s) and
keep away from spark plug(s) to prevent
accidental starting;
WARNING : Always use the chute shovel supplied with
the snowblower in order to unclog the snowblower,
never use your feet or hands.