Berbel Moveline BTH 100 ML, Инструкции по эксплуатации и монтажу

Страница: 23 / 36

23
Operation
6004067_a – 01.08.2018
EN
4.2 Control panel
The device is controlled via the control panel.
The position of the control panel can be seen in the trough
of the ON/OFF button at any time. The remaining touch fields
illuminate if the device is switched on.
After switching on the mains power supply, the device needs
a few seconds in order to adapt itself to the environmental
conditions. During this time, it cannot be operated.
Touching a touch field executes the corresponding function:
y Touch field illuminates dimly = Function not active
y Touch field illuminates brightly = Function active
Touch
field
Function
ON / OFF, access configuration mode
Recirculated air mode, check filter filling
indicator
Hob lighting
Effect lighting - no function
Power level 1
Power level 2
Power level 3
Power level POWER (max. 6 minutes)
Lift function “Extend”
Lift function “Retract”
4.3 Normal operation
Touch
field
Function
The device is turned off.
☞
Touch the touch field 1x.
The device switches on.
The device is switched on.
☞
Touch the touch field 1x.
The device switches off.
If the run-on function is activated:
The run-on time (10 minutes) starts
automatically in the last selected power level.
Touch field illuminates brightly:
Recirculated air mode is switched on.
Touch field flashes:
The filter filling must be replaced.
Touch field illuminates brightly:
Hob lighting is switched on.
Touch field illuminates brightly:
Effect lighting (optional) is switched on.
Touch field illuminates brightly:
Power level 1 (lowest fan power) is active.
Touch field illuminates brightly:
Power level 2 (medium fan power) is active.
Touch field illuminates brightly:
Power level 3 (high fan power) is active.
Touch field illuminates brightly:
POWER power level (max. fan performance)
is active for max. 6 minutes. Then the device
switches to power level 3.
The touch fields are only active if the device is
switched on.
☞
Touch the touch field 1x.
The device moves in the desired direction.
If the touch field is actuated during
movement, the device stops in the current
position.
The device moves to the appropriate end
position without further actuation.
As soon as the device is fully retracted, all
active functions are switched off.