BEPOWEREQUIPMENT 120 GALLON HORIZONTAL, Руководство пользователя

Страница: 11 / 28

11
NOTICE
For compressor tank to have full manufacturer warranty. The tank must
be installed properly on manufacturer supplied vibration pads per
compressor manual. Failure to do so can void compressor tank
warranty and cause tank cracks or failures.
On Electric compressors all electrical connections must be wired and
installed per NEC (National Electric Code) (See the back of the manual
for NEC code) and all local applicable codes for full electric component
warranty. Failure to do so can void compressor electrical warranty.
Installation
LOCATION
Locate the compressor in an indoor area that is clean, dry, well lighted,
and well ventilated, with sufficient space for safe and proper inspection
and maintenance. Ambient temperatures should not exceed 104 degrees.
For fall below 30 degrees unless an electric motor rated for a higher
temperature is used. Inspection and maintenance checks are required
daily, therefore, ample space is required around the compressor.
The compressor must not be installed closer than fifteen inches from a
wall or from another compressor to allow ample circulation or air across
the compressor cylinders and head, and through the coolers if they are
part of the system. Additional safety can be achieved by locating the
pulley guard next to the wall.
MOUNTING
The use of the factory supplied rubber vibration isolation pads, or other
factory supplied vibration isolation mounting equipment is required for
tank warranty from the original tank manufacturer. The compressor should
never be left on original shipping material for installation. If a shim is
required to level the unit, place it between the pad and floor. If you bolt
the unit to the floor, use the bolts as guide pins and do not tighten the
bolts. The rubber pads are used to absorb machine vibration and cannot
work effectively if bolted tightly.
INDUCTION SYSTEM
Do not locate the compressor where it could ingest or ignite toxic,
explosive or corrosive vapors, ambient air temperatures exceeding 110
degrees F, water or extremely dirty air. Ingestion of any of the above noted
atmospheres by the compressor could jeopardize the performance of the
equipment and all personnel exposed to the total compressed air system.
Destructive pulsations can be induced by reciprocating compressors that
will damage walls and break windows. Pulsation can be minimized by
adding a pulsation dampener on the inlet side of the compressor.
installation