To reset the gateway:
1. Navigate to
Maintenance
.
2. Select the
Restart
menu item.
3. Select
Soft Restart
or
Power Cycle
.
IPv4 Address Reset
To reset the Ranger Pro Gateway IPv4 address using a magnet:
1. Place a magnet against the magnet icon located on the Ranger Pro Gateway until the
status indicator starts flashing between green and amber.
2. Hold the magnet in position for approximately 5 seconds.
3. The status indicator should start flashing between amber and red indicating that the IPv4
address has been reset to factory default (
192.168.1.1
).
4. Remove the magnet.
To reset the Ranger Pro Gateway IPv4 address by using the A-coded M12 auxiliary power
connector:
1. If in a non-hazardous environment, connect pin 2 to pin 3 (white to blue wire) until the
status indicator starts flashing between green and amber.
2. Maintain the connection for approximately 5 seconds.
3. The status indicator should start flashing between amber and red indicating that the IPv4
address has been reset to factory default (
192.168.1.1
).
Remove the magnet or auxiliary power reset connection within 10 seconds of starting
the process to prevent the device from entering the factory default restore process.
6.5 Restore Factory Defaults
To use a magnet to restore the gateway to the factory default settings:
1. Place a magnet against the dot icon located on the front label of the Ranger Pro Gateway
until the status indicator starts flashing between green and amber.
2. Hold the magnet in place for approximately 15 seconds while the status indicator starts
flashing between amber and red and then changes to a steady red. This begins the
factory default restoration process.
3. After a few minutes the TCP/IP IPv4 address will be reset to factory default
(
192.168.1.1
), all user configurations will revert to the factory default and device software will
be reverted to the factory installed version.
Alternatively, if in a non-hazardous environment, use the auxiliary power connection reset
option by connecting pin 2 to pin 3 (white to blue wire) until the status indicator starts flashing
between amber and red. Remove the connection after 15 seconds.
44/46
Ranger Pro ISA100 Wireless Gateway
User Guide
158M1430 Rev. -
