Section 3 — Installing the Hardware
7
3.2.1
Installing the Vibration Transducer Interface Modules
Install Vibration Transducer Interface modules on the backplane (refer to the
3500 Field Wiring Package (130432-01)). To install a Vibration Transducer
Interface module:
1. Attach a position label (NOT supplied) where shown if necessary. The label
identifies the location of the module on
the backplane.
2. Position the Vibration Transducer
Interface module onto the appropriate
safe-area/power supply connector on
the backplane as shown and insert it
onto the connector. This connects the
module to the appropriate safe-area
connector (pins 7 and 8) and to the
power supply.
3. Tighten the two mounting screws
where shown.
1) Position
Label
2) Mounting
Screw
3)
Safe Area/Power Supply Base
Connector
4) Backplane
3.2.2
Installing the Hazardous-area Screw Clamp Connector
1. Trim the insulation of the wire back 12 mm. The wire
should be between 16 and 22 AWG.
2. Insert the wires according to the socket assignment
(see the 3500 Field Wiring). Tighten the screws of the
connector as shown.
3. Attach a tag label where shown if necessary.
4. Position the hazardous area connector over the
appropriate Vibration Transducer Interface module
and insert as shown.
