Bentel Security KYO 100, Руководство пользователя

Страница: 13 / 24

USER MANUAL KYO100-KYO300 13
Change Telephone numbers
This command will allow you to change the first eight
Telephone numbers in the Phonebook.
To program or change the Telephone numbers:
1. Using
C
and
D
scroll the 8 Telephone numbers.
@: & )
@
2. Press
E
to select the number to be programmed or
changed.
The display will show the current Telephone number,
or an empty programming field (the first digit will blink
to indicate that it is ready for programming).
12 -
:.::
3. Using keys
1
through
9
, enter the telephone
number.
—
o
corresponds to the pound sign (#);
—
O
corresponds to pauses (*);
—
A
and
B
will allow you to move the cursor along
the line and overwrite wrong digits.
To delete the entire Telephone number, press and
hold
1
until the keypad emits a beep.
4. Press the
e
key to go back to step 1 .
Reset PC programming
When the system is programmed from a computer (on-
site or via Modem) or a Keypad, the
Control panel will
trigger the Programming Start event.
The Control panel classifies this event as a Trouble con-
dition, therefore, it will be signalled on the
G
LED.
To view this Trouble condition, you must access View Trou-
ble mode, the display will show the following message:
)&&)*
0&&:
To clear this Trouble condition—select the Reset PC
Prog. option from the User menu and press the
E
key,
the display will show the following message for several
seconds and the
G
LED will turn OFF (unless there are
other Trouble conditions present).
&$#&
.32/
Programming PIN codes
If your Installer has set up the User Code hierarchy ( Mas-
ter and Slave Codes).
This command will allow Master Codes to select/
deselect the Active status of their Slave Codes (Enable/
Disable Slave Codes), and change their Slave Code PINs.
This command is available to Master Codes only .
Active Slave Codes can access the system and control
their enabled Partitions and functions.
To allow/deny system access to a Slave Code:
1. Use
C
and
D
to scroll the Slave Codes list (ac-
cessed by the Master Code).
9/ -
9/
2. Press the
E
key to select the required Code.
9/
0,
3. Press the
O
key to select Active status, or
o
to
deselect Active status, as required.
A Code can be both a Master and a Slave (i.e. Slave
of one Code, and Master of another). A Master Code
cannot deselect the Active status of a Slave Code
that is Master of another Slave Code.
To change the PIN of a Slave Code:
1. Use
C
and
D
to scroll the list of Slave Codes (ac-
cessed by the Master Code).
9/ -
9/
2. Press the
E
key to select the required Code.
9/
0,
3. Press the
E
key again, the display will show the fol-
lowing message: