USER MANUAL
12
When you select this command, the display will show
the following message:
- +-+--
+7!/-'44
Press
O
to
Enable
the Answering device facility.
Press .
o
to
Disable
the Answering device facility.
Press the
E
key to confirm and step back to the User
menu.
If the Answering device facility is enabled, an
*
will
be shown on the display directly above the
r
.
Activating Outputs (Turning ON/OFF Appliances)
If your Installer has set up your system to control appli-
ances (sprinklers, lights, etc.), this command will allow
you to turn the appliances ON/OFF manually.
To turn ON/OFF Outputs (appliances):
1.
Use
C
and
D
to scroll the list.
1)&)&
;&
2.
Press the
E
key to select the required Output (appli-
ance). The display will show the current status.
#+0,
8$98%
3.
Press
O
or
o
, as required.
Use
C
and
D
to continue scrolling the list
4.
Press the
e
key twice to confirm and step back to
the User menu.
Clear call queue
If your Installer has programmed your Control panel to
send Alarm calls, it will call the programmed telephone
numbers each time an Alarm occurs. In the event of a
False Alarm, this command will allow you to interrupt
the ongoing call, and clear the call queue.
If you select this command the display will show the
following message:
+<2 ++=;<;<
,#
To confirm the Command
Press the
E
key.
The display will show the following message for sev-
eral seconds before stepping back to the User menu:
+<2 ++=;<;<
To Abort the Command
Press the
e
key to step back to the User menu.
Overtime request
If the Auto-arm option is enabled, and the system is pro-
grammed to Arm automatically at a preset time, the Over-
time request will allow you to delay the Auto-arming
event.
Acceptance of the Overtime Request will be confirmed by
an audible feed back signal and the following message:
1><23<2<=;<0
If any of the Partitions concerned is unable to imple-
ment the Overtime request, the Keypad will emit an
audible error signal.
The Installer will set up the Auto-arm and Overtime Re-
quest events with your installation in mind, and will pro-
vide you with all the necessary information (regarding
the partitions involved, and the number of Overtime re-
quests you can make before an Auto-arm event).
Change Time and Date
This command will allow you to set the current Date and
Time.
You cannot change the Time and Date when Parti-
tions are Armed.
1.
Using
C
or
D
select NEW TIME - DATE, then
press
E
.
?<63<.!<
9
2.
Enter the New Time and Date, then press
E
to con-
firm and go to the next step (Date format), or
e
to quit
and step back to the USER MENU.
The New Time and Date field will not allow you to
change the digits individually, therefore, you must
enter the entire Time and Date. If you press
E
before
completion, the setting will be deleted.
!&
,&
@@
''''
3.
Using C or
D
select Date format:
hh:mm dd/mm/yyyy
hh:mm mm/dd/yyyy
hh:mm yyyy/mm/dd
then press
e
to confirm and go back to step 2.
Содержание KYO 100
Страница 1: ......
