14
890053-03-01
Description of Keypad Parameters
9.2 Configuration Group (CNF)
①
[CNF-30] Option-1 Type: Display the type of option slot 1
It automatically displays the type of communication option board currently
installed in H2. When the communication option board is mounted in the H2
inverter, it is automatically displayed as name of the option board.
** Depending on the inverter version, it may be displayed as “Reserved-18” instead of
by name.
9.3 DRV Group
①
[DRV-06] Cmd Source: Command Source
Select the command source for the H2
inverter. Set to “4 (Field Bus)" to set the
communication board as the command source and provide commands via
network.
②
[DRV-07] Freq Ref Src: Frequency reference source
Select the frequency reference source for the H2
inverter. Set to “7 (Field
Bus)" to set the communication board as the frequency reference source and
provide the frequency reference via network.
9.4 COM Group
①
[COM-06] FBus S/W Ver: Communication option S/W version
Automatically indicates the version of the communication board installed to the
H2 inverter.
②
[COM-07] FBus ID: Station ID of the communication board
(communication board ID)
Set the station ID for the H2 communication board. A total of 255 station IDs
are available from 0 to 255. (The station ID must be set before you can
configure network communication using the protocol.)
When setting the station ID, be careful not to use a station ID that is not
already occupied by the PLC system or other network devices.
After making setting changes, you must set COM-
94 (Comm Update) to “1
(Yes)” before the changes can take effect.
