Using the remote control
8
Eng
lish
Using the remote control
• Do not cover the sensor window on the front of the display (below the power
indicator lamp), or place objects in front of it which will block the direct line-
of-sight between the remote control and the sensor window on the display.
• Do not let the remote control become wet, or place it in humid environments
(like bathrooms.)
• If the remote control sensor window on the display is in direct sunlight or
strong light, the remote control may not operate properly. In this situation,
change the light source or readjust the angle of your display, or operate the
remote control from a location closer to the remote control sensor window on
the display.
Power on, off and standby
Turning the display on
After plugging the display's power cable into a wall outlet and turning on the
main power switch, the display will enter standby mode automatically, and the
power indicator will light up red. Press
Power/standby
on the remote
control. The display will turn on and the power indicator will change to green.
Putting the display to standby
When the display power is ON (the power indicator lights up green), press
Power/standby
on the remote control, and the display will return to
standby mode. The power indicator will turn red.
The display still consumes about 1W of power in standby mode.
Turning the display off
You can turn the display power off by flipping the main power switch on the
display to the off (O) position. The power indicator will be off.
Switching inputs
1. Turn on all connected equipment or devices before selecting an input.
2. Press
訊號來源
(Input)
on the remote control to display the current selected
input. Press the button repeatedly until your desired input is displayed.
The sequence is as follows:
• Point and aim the top front of the
remote control directly at the display
when pressing the buttons.
• The remote control must be held at an
angle within 30 degrees of the display's
remote control sensor window to
function correctly. The distance
between the remote control and the
sensors should not exceed 6 meters.
6 meters
30 degrees
AV1
AV2
AV3 (or AV3-S)
HDMI1 (or DVI)
HDMI2 (or DVI)
PC
S37Y_S42Y-Tuner-RC-EN-4J.01A05.001.book Page 8 Tuesday, April 10, 2007 5:02 PM
