Operation
21
Securing the projector
Using a security cable lock
The projector has to be installed in a safe place to prevent theft. Otherwise, purchase a
lock, such as the Kensington lock, to secure the projector. You can locate a Kensington
lock slot on the rear side of the projector. See item 16 on page
for details.
A Kensington security cable lock is usually a combination of key(s) and the lock. Refer to
the lock’s documentation for finding out how to use it.
Utilizing the password function
For security purposes and to help prevent unauthorized use, the projector includes an
option for setting up password security. The password can be set through the On-Screen
Display (OSD) menu.
WARNING: You will be inconvenienced if you activate the password functionality and subsequently forget the
password. Print out this manual (if necessary) and write the password you used in this manual, and keep the
manual in a safe place for later recall.
Setting a password
Once a password has been set and the power on lock is activated, the projector cannot be used unless the
correct password is entered every time the projector is started.
1.
Open the OSD menu and go to the
SYSTEM SETUP: Advanced
>
Security
Settings
menu. Press
MODE/ENTER
. The
Security Settings
page appears.
2.
Highlight
Change Security Settings
and press
MODE/ENTER
.
3.
As pictured to the right, the four arrow keys
( ,
,
,
) respectively represent 4 digits
(1, 2, 3, 4). According to the password you
desire to set, press the arrow keys to enter six
digits for the password.
4.
Confirm the new password by re-entering the
new password.
Once the password is set, the OSD menu
returns to the
Security Settings
page.
5.
To activate the
Power On Lock
function, press / to highlight
Power On Lock
and press /
to select
On
.
IMPORTANT: The digits being input will display as asterisks on-screen. Write your selected password down
here in this manual in advance or right after the password is entered so that it is available to you should you
ever forget it.
Password: __ __ __ __ __ __
Keep this manual in a safe place.
6.
To leave the OSD menu, press
MENU/EXIT.
If you forget the password
If the password function is activated, you will be asked
to enter the six-digit password every time you turn on
the projector. If you enter the wrong password, the
password error message as pictured to the right will
appear, and the
INPUT PASSWORD
message
follows. You can retry by entering another six-digit
password, or if you did not record the password in this
INPUT NEW PASSWORD
Back
MENU
Password Error
Please try again.