Preparation
7
Your projector is now connected to your local area network and can be accessed by any
devices linked to the same local area network.
Connecting your computer to the projector via a wired
connection
Follow the steps below to connect your computer to the projector through the local area
network:
1.
Ensure the projector is connected to the local area network. You can enter the
Wired LAN
page to check if the
IP Address
,
Subnet Mask
,
Default Gateway
,
and
DNS Server
are configured as needed and if the
Status
is
Connect
.
2.
Connect your computer to the same local area network via an RJ45 cable.
Now your computer and the projector are on the same local area network.
Alternatively, to check the IP address of the projector, make sure the projector is connected to the
network, and press
SOURCE
on the projector and then select
Network Display
. The IP address
is displayed on the bottom left corner of the
Network Display
screen.
Your computer should be properly configured to detect a wired network connection. Check the
user manual of your computer or visit the manufacturer’s website for information on how to
configure a wired network connection.
