Managing the projector using a web browser
30
Managing the projector using a web browser
Once the projector is connected to a wired local area network and the projector is on or
in standby mode, you can use any computer that is in the same network to manage and
control the projector via
BenQ Projector Control System
accessed through the
computer’s web browser.
Supported web browsers
Make sure you are using one of the following web browsers:
• Internet Explorer: 9 / 10 / 11
• Chrome: 55.0 / 56.0 / 57.0
• Safari: 8.0 / 9.0 / 10.0
• Firefox: 50.0 / 51.0 / 52.0
Configuring
Standby Settings
for the projector
In order to control the projector remotely while the projector is in standby mode, you
need to enable the Network Standby Mode and Monitor Out settings for the projector. To
do so, follow the steps below:
1.
Press
MENU
on the projector to open the
Advanced Menu
options.
2.
Highlight
System
and press
OK
.
3.
Highlight
Standby Settings
and press
OK
.
4.
Highlight
Network
and press
OK
.
5.
Highlight
Enable Network Standby Mode
and press
OK
.
6.
Select
On
then press
OK
.
7.
Press
BACK
to return to
Standby Settings
.
8.
Highlight
Monitor Out
and press
OK
.
9.
Select
On
then press
OK
.
Accessing the
BenQ Projector Control System
1.
Make sure your computer and the projector are connected to the same local area
network. See
for details.
2.
Launch the web browser on your computer.
3.
Enter the IP address of the projector in the browser’s address bar and press the
computer’s
Enter
key.
