Operation
20
Correcting keystone
Keystoning refers to the situation where the projected image becomes a trapezoid due to
angled projection.
To correct this, besides adjusting the height of the projector, you will need to manually
correct it following ONE of these steps.
• Using the remote control
Press
/
on the projector or remote control
to display the Keystone correction page. Press
to correct keystoning at the top of the image. Press
to correct keystoning at the bottom of the
image.
• Using the OSD menu
1.
Press
MENU/EXIT
and then press / until the
DISPLAY
menu is highlighted.
2.
Press
to
highlight
Keystone
and press
MODE/ENTER
. The
Keystone
correction page is displayed.
3.
Press
to correct keystoning at the top of the image. Press
to correct
keystoning at the bottom of the image.
Press
/
.
Press
/ .
