HIGH RAIL
PLUS
INSTALLATION
For Benno
®
Boost (EVO 4,5) Rear Racks PLUS
READ CAREFULLY BEFORE INSTALLATION AND USAGE. TO BE INSTALLED BY MECHANIC AT AUTHORIZED BENNO DEALER.
IMPORTANT:
The High Rail
PLUS
can only be installed with
the Rail Clamps
PLUS
on the Boost Rear Rack
PLUS
.
(All Boost model year 2020 and later come standard with a Boost Rear Rack
PLUS
)
26”/ 66 cm
Boost Rear Rack
PLUS
IMPORTANT:
Notes to mechanic:
See diagram. Install Benno Rail
Clamps PLUS and Rails PLUS only on compatible Benno Boost
Rear Racks PLUS and use only pre-drilled holes and fittings. M5
bolts are to be tightened to 5Nm and M6 bolts to 6Nm. Do not
mount clamps and rails to damaged racks. Use only original
Benno Rails PLUS with Benno Rail Clamps PLUS. Do not modify
clamps, racks or rails, change position or drill new holes as this
will void any warranties and/or claims for liability.
Notes to owner:
Periodically check to make sure all nuts and bolts
remain tightened as vibrations may loosen them. Ensure that
either Benno Wheel Guards or Utility Pannier Bags remain on the
bike while carrying passengers. Always make sure no parts of the
body or clothing come near moving parts on the bicycle such as
chain, spokes, tires or brakes.
STEP 1: RAIL CLAMP
PLUS
INSTALLATION
(NOT INCLUDED / SOLD SEPARATELY)
2. Place one clamp on each end of the rack
(front and rear). Insert clamps from below
and line up with the two fittings on the
underside of the rack.
1. Ensure correct hardware count before
installation. Included are two clamps and
four M6 bolts and washers.
3. Insert the two M6 bolts through the
slotted holes of the clamp and screw into
the fittings on the underside of the rack.
HAND-TIGHTEN BOLTS SLIGHTLY — CLAMPS
STILL NEED TO BE ABLE TO MOVE.
4. Insert both lower ends of left rail (A)
from the left side all the way into the
center of the clamps until they come to
a stop. Loosen clamp bolts as needed for
easy insertion. DO NOT TIGHTEN YET.
Then connect rear rail (B) to the upper
end of the left rail (A) as shown. Use M6
bolt, spacers and nut as shown to ensure
connection between rail (A) and rail (B).
FRONT
REAR
STEP 2: HIGH RAIL
PLUS
INSTALLATION
COMPATIBILITY
BOOST
FOR BOOST EVOLUTION FINDER GO TO:
BENNOBIKES.COM/BOOST/EVOLUTION
EVO 4,5
EVO (evolution) replaces model years and refers
to design generations.
