Device description
4.2 Functions
5178 / 03/2021 en
BENNING EV 3-2
15
Pin assignment
Figure 2:
Assignment of the Type 2 connector for connection to the charging station (EVSE)
4.2
Functions
The device is intended for the following tasks:
• Simulating an electric vehicle (EV) for the charging station
• Providing safe contacting for the installation tester
The simulation of the charging cable and electric vehicle used is done via the rotary switches
“PP-Status/State” and “CP-Status/State” of the device.
Rotary switch “PP-Status/State” for cable simulation
With the rotary switch “PP-Status/State” you can simulate different codings of the charging
cables. The coding describes the maximum permissible current carrying capacity of the
charging cable. By means of the switch position, different resistance values are switched in the
device between the PP and PE contacts.
Switch position
Simulation
Resistance (PP-PE)
N.C.
No charging cable connected
or error.
Open (∞)
13 A
Coding of the charging cable
or maximum charging current
1 500 Ω
20 A
680 Ω
32 A
220 Ω
64 A
100 Ω
Table 4:
Switch positions of the “PP-Status/State” rotary switch
