12
MENU
FUNCTION
ON-OFF
(Default)
MEMO
LOGIC
In 1
Presetting of the channel status (normally open/ normally closed).
IST: Channel preset as “Gate input status” See section “Gate input status”.
NO: Channel preset for a NO (normally open) input.
NC: Channel preset for a NC (normally closed) input.
(NO)
In 2
Presetting of channel 2 status Same options as channel 1.
----
-------
In 6
Presetting of channel 6 status Same options as channel 1.
MENU
FUNCTION
RADIO
add
OUT 1
Outputs 1/2/3/4 can be activated by a radio transmitter.
Select the desired output, the receiver awaits for (
Push
) a transmitter code to be as-
signed to the channel.
Press the transmitter key to be assigned to the output.
If the code is valid, it will be memorised and
OK
is displayed on the monitor.
If the code is not valid, the message
Err
is displayed.
OUT 2
OUT 3
OUT 4
code
roll
The reception of variable transmitter codes is enabled/disabled (default ON).
bYou
The reception of BYOU transmitter is enabled/disabled (default ON).
fiX
The reception of programmable transmitter is enabled/disabled (default ON).
CLR
If this function is selected, the receiver waits for (
Push
) a transmitter code to be erased from memo-
ry.
If the code is valid, it will be erased and
OK
is displayed on the monitor.
If the code is not valid, or it is not in memory, the message
Err
is displayed.
res
The receiver memory is totally erased. When the wording
PUSH
is displayed, the operation must be
confirmed.
(During reset, the
RES
wording flashes. At end of reset,
OK
is displayed).
MENU
FUNCTION
tar
Measurement of the current consumption in standby (powered control unit with stopped motor).
The operation needs to be confirmed. During measurement, the wording
MIS
flashes.
At conclusion of the operation, the system returns to TAR Menu.
The value is memorised and used by ESA-BASIC as reference of consumption in stand-by, for the
counting of the TOFF time. In order not to have an incorrect reading, the measurement shall be at
motor stopped.
iout
The value (expressed in Amperes) of the output current that ESA-BASIC supplies to the control unit
is displayed.
res
RESET. WARNING!: Restore ESA-BASIC to default values.
With the first pressure of the <PG> push button, the message
PUSH
is displayed. If the push button is
pressed again, the message
PROG
is displayed and then
OK
is displayed at end of reset.
Note: The transmitter codes are not erased from the receiver.
Intelligent Security & Fire Ltd.
