10
ENERGY-SAVING DEVICE ESA BASIC
DESCRIPTION
ESA BASIC is a device which has been specially studied, designed and patented to allow for annual energy savings up to
250kW (indicative value for standard installation).
This equipment can be installed onto any new or already existing automatic systems, of any type whatsoever (sliding doors,
swing doors, garage doors, etc.), manufactured by our company or by other producers.
Esa Basic can be also used in systems which are not intended for the automation of doors or gates (e.g. irrigation sprinklers,
etc.). In any case, after installing ESA BASIC, the installer shall be responsible for the checking of the correct operation of
the system.
The manufacturer shall not be deemed responsible for any malfunctions.
OPERATION
Esa Basic must be connected between the mains power supply and the control unit.
The push-button controls (Step-by-step, STOP, OPEN, CLOSE, SERVICE MAN, PHOT, Etc.) must be disconnected from
the control unit and connected to the ESA BASIC board (see Fig. 2).
The radio receiver codes must be removed from the receiver of the control unit and stored in the incorporated radio re-
ceiver memory (433.92MHz, rolling-code/fixed code/transmitters BYOU series) of the ESA BASIC card (prior check that
the transmitter used are compatible).
The ESA BASIC card keeps the system in “SLEEP” mode for the time it is not used. Energy consumption is therefore
reduced.
Only when the command is sent to the installation, the ESA BASIC card reactivates the system and sends the appropriate
control signal to the control unit. After a presettable time, the system returns to the SLEEP mode.
WIRE DIAGRAM
The electric connections shown in Fig. 1 are described in the following table:
Terminals
Function
Description
1-2
Mains power
supply
Input, mains power supply.
ESA BASIC accepts power supply voltages ranging from 85 to 260 VAC.
3
COM
Common to all control inputs.
4-COM
IN 1
Input, contact of command 1. It is configurable for NO, NC or IST contact.
It is preset as NO input by default.
5-COM
IN 2
Input, command contact 2. Same characteristics as input 1.
6-COM
IN 3
Input, command contact 3. Same characteristics as input 1.
7-COM
IN 4
Input, command contact 4. Same characteristics as input 1.
8-COM
IN 5
Input, command contact 5. Same characteristics as input 1.
9-COM
IN 6
Input, command contact 6. Same characteristics as input 1.
10-11
OUT 1
Output, channel 1. It replicates the status of input 1 or, alternatively, it can be matched
to a radio transmitter.
12-13
OUT 2
Output, channel 2. It replicates the status of input 2 or, alternatively, it can be matched
to a radio transmitter.
14-15
OUT 3
Output, channel 3. It replicates the status of input 3 or, alternatively, it can be matched
to a radio transmitter.
16-17
OUT 4
Output, channel 4. It replicates the status of input 4 or, alternatively, it can be matched
to a radio transmitter.
18-19
OUT 5
Output, channel 5. It replicates the status of input 5.
20-21
OUT 6
Output, channel 6. It replicates the status of input 6.
22-23
Antenna
Connection of the antenna to the incorporated radio-receiver module
22 SHIELD: Screen / 23 ANT: Control signal.
24-25-26
SLEEP output
Output, power supply of the control unit: 250Vac/16A maximum. Through this contact,
the control unit is activated or deactivated by ESA BASIC.
Intelligent Security & Fire Ltd.
