BeneVision TMS60, Руководство оператора

Страница: 127 / 250

Monitoring with the TMS60 at the CMS Monitoring at the CMS (Version Earlier than 03.00)
TMS60 Operator’s Manual 12 - 9
12.2.2 ECG Monitoring
At the CMS, you can view and change the heart rate (HR), QT, ST, and arrhythmia settings
in the
ECG tab of the Parameter Setup menu.
For details about the Parameter Setup menu, See the BeneVision Central Monitoring
System Operator’s Manual .
At the CMS, you can view and change the ECG settings in the ECG tab. To enter the ECG
tab, follow this procedure:
1. Select the ECG digital area or waveform area to enter the Parameter Setup menu.
2. Select the ECG tab.
12.2.2.1 HR Settings
The following table lists the HR settings in the HR section of the ECG tab.
Options or Buttons Description Settings*
HR Activation State Configures whether or not to enable the
HR alarm. See " Factory Default Parameter
Alarm Settings" on page 12 - 3 for
details.
HR Alarm Priority Configures the HR alarm levels.
HR High Limit (bpm) Configures the HR high alarm limit.
HR Low Limit (bpm) Configures the HR low alarm limit.
Sweep Speed Configures the ECG wave speed. 6.25 mm/s, 12.5 mm/s, 25 mm/s ,
50 mm/s
HR Source Configures the HR source. ECG , SpO
2
, Auto, Both
HR Record on Alarm Select whether or not to activate the
option to direct the CMS to send the HR
alarm data to the configured recorder. On, Off
Waveform Setup Select to display the Waveform Setup
menu.
See "Waveform Setup" on page
12 - 10 for details.
Other Settings Select to display the Other Settings
menu.
See "Other Settings" on page 12 -
12 for details.
* The factory default settings are in bold.