PART A: CONFIGURING SETTINGS FOR THE TRACKBOX
34 I/O SETTINGS
Digital output pins
ACTIVATING DIGITAL OUTPUT PIN
•To activate an output pin, check the
Activity
box (1).
•NOTE: The output pin is NOT in use when the check box
is left blank. A signal of the pin is not detected at all.
SETTING EVENT STATE
Determine
Event state
for the digital output pin. The circuit
can be set for
High
or
Low
. Click the arrow and highlight the
desired option (2).
A change in the event state causes grounding of a pin. The
change can be done by sending a specific MPTP message to
the device. The desired action can be, e.g. swiching an elec-
tric sauna on remotely.
After the change is registered, the device responds to an
event the way, it is configured in the
Event
data field (see be-
low).
SELECTING EVENT
You can determine the way, the device responds to an event.
Click the arrow on the
Event
data field and highlight the de-
sired option (3).
•
No action
: The device does not send or log anything.
•
Send status message
: The device sends status message of
the event as a reply to the requesting number.
•
Write in event log
: The device only writes down the event
in the
Event log
.
•
Send and write
: The device sends status message of the
event as a reply to the requesting number and writes
down the event in the
Event log
.
3
2
1
Содержание TRACKBOX 2.1
Страница 6: ...6 ...
Страница 26: ...PART A CONFIGURING SETTINGS FOR THE TRACKBOX 26 TELEMATIC SETTINGS General telematic settings 1 3 4 5 2 ...
Страница 35: ...I O SETTINGS 35 PART A CONFIGURING SETTINGS FOR THE TRACKBOX Digital input pins 1 4 3 5 2 6 8 7 ...
Страница 38: ...PART A CONFIGURING SETTINGS FOR THE TRACKBOX 38 I O SETTINGS Analogue input pins 8 7 6 5 4 3 2 1 9 ...