BendPak SP-7XE, Инструкция по установке и эксплуатации, Страница: 10 / 68

SP-7XE/F Full-Rise Scissor Lift
10
P/N 5900010 — Rev. B — June 2022
Frequently Asked Questions
Question : How much weight can the SP-7XE/F raise?
Answer : The SP-7XE/F can raise Vehicles up to 7,000 pounds (3,175 kg).
Q : The SP-7XE F is described as “flush mount”, what does that mean?
A : It means the Bases of the SP-7XEF are installed
below
the surface of the Concrete, in Concrete
Cutouts. The tops of the Platforms are flush with the Concrete floor, so Vehicles just drive straight
on—no Drive-up Ramps are required. Sufficient Concrete depth is required
under
the Concrete
Cutout. See
Prepare the Concrete Cutouts: SP-7XEF only
for more details.
Q : The SP-7XE/F is called a “Full-Rise” Lift, what does that mean?
A : It means that the SP-7XE/F can raise a Vehicle almost six feet off the ground, which is higher than
most other Scissor Lifts. Additionally, the SP-7XE/F has eight Safety Lock positions, which means
you can lock the Lift at the height most convenient for what you are doing.
Q : Can the SP-7XE/F be installed outside?
A : No. The SP-7XE/F is approved for indoor installation and use only.
Outdoor installation is
prohibited
.
Q
: Can I put the Console on either side of the SP-7XE/F?
A : Yes. The Hydraulic Hoses that come with the SP-7XE/F are long enough to support the Console
being up to 40 inches (999 mm) away from a Base on either side.
Q : What if I want to raise a Vehicle that is slightly over the weight capacity of the Lift?
A :
This is not an intended use of the product
. We strongly recommend
against
trying to
raise a Vehicle that is heavier than the rated capacity of your Lift. If you do, you void your warranty,
you could damage the Lift and/or the Vehicle you are raising, and you jeopardize the safety of
people near the Lift.
Q : What do the Safety Locks do?
A : Safety Locks use gravity and intelligent engineering to hold the Platforms up, once the Safety
Locks are engaged. Even if the Lift loses power or the Hydraulic Hoses are cut, the Platforms stay
where they are if they were left engaged on a Safety Lock.
Only leave your Lift either fully
lowered or engaged on a Safety Lock!
Q : Which end of the SP-7XE/F is the “front”?
A
: There is no front or back. You can drive Vehicles onto and off of the Lift in either direction.
Q
: The SP-7XE/F is described as “frame-engaging”, what does that mean?
A : It means the Platforms (specifically the Rubber Blocks on the Platforms) contact the frame of the
Vehicle to raise it. Put another way, the Vehicle is
not
raised by its wheels.
Q : The space between the Platforms is too wide for my small Vehicle. What can I do?
A : You can purchase the optional Lift Arm Kit. The Lift Arms extend into the space between the
Platforms, providing additional options for smaller Vehicles.
Q : Is there a Lift Arm Attachment for the SP-7XE?
Y : See page 51 for more information on the optional Lift Arm Kit.