LR-10000 Low-Rise Scissor Lift
30
P/N 5900075 — Rev. A1 — April 2019
Operation
This section describes how to operate your Lift.
⚠
WARNING
Use care around the Lift. When it is in a lowered position, be careful not to trip over
it. When it is raised, be careful not to bang into the Ramps or the Platforms.
When
the lift is moving, keep everyone at least 30 feet away
from it
.
Lift Operation Safety
BendPak recommends referring to the ANSI/ALI ALIS Standard (R2015)
Safety Requirements for
Installation and Service
for more information about safely installing, using, and servicing your Lift.
Before you raise or lower a Vehicle using your Lift, do the following each time:
•
Check the Lift
. Check the Lift for any missing, heavily worn, or damaged parts. Do not operate
the Lift if you find any issues; instead, take it out of service, then contact your dealer, email
, visit
, or call
(800) 253-2363
, x196.
•
Check the area
. Check the area around the lift for obstructions; anything that might block the
Lift. Do not forget to check
above
the Lift. If you find an obstruction, move it out of the way.
•
Check the operators
. Make sure everyone who is going to operate the Lift has been trained in
its use, has read the labels on the unit, and has read the manual. Only the operator at the Console
should be within 30 feet of the Lift when it is in motion.
•
Check for safety
. Make sure everyone who is going to be walking near the Lift is aware of its
presence and takes appropriate safety measures. Only put Vehicles on the Lift.
When raising
the Lift, do not leave it until it is engaged on a Safety Lock
. When lowering the Lift, do
not leave it until it is fully lowered. Do not allow children or untrained personnel to operate the Lift.
Do not allow anyone under the influence of drugs or alcohol to operate the Lift.
•
Check the Vehicle
. Never exceed the Lift’s weight rating. Do not allow people inside a Vehicle
you are going to raise. Before raising it, make sure the Vehicle is not overbalanced on either end.
Make sure you know and use the manufacturer’s recommended Lifting Points for the Vehicle.
Never raise just one side, one corner, or one end of a Vehicle.
Содержание LR-10000
