1
Quick Set-Up Guide
SmarTire Trailer-Link
™
Tire Pressure Monitoring System (TPMS)
SAFETY
Follow all industry standard maintenance safety precautions, including wearing appropriate eye protection. See the
General Safety Guidelines on the other side.
IMPORTANT
This SmartTire
®
TPMS kit is pre-programmed and ready to use, subject to your application:
● The sensors have been PRE-ASSIGNED TO WHEEL POSITIONS and are identified on each unit with a position
label (P1, P2, P3, etc.). Install the sensors as per the diagram below.
● Default values have been assigned to each axle for the following (depending on kit configuration):
► Cold Inflation Pressure (CIP) – preset to 100 PSI
► First Alert Level (FAL) – preset to ±15% from expected (temperature compensated) value
► Second Alert Level (SAL) – preset to -20% from CIP
► High temperature alert (optional) – 185°F (85°C)
INSTALLATION STEPS:
1. Install the tire sensors in the pre-programmed locations by following “Section B - System Installation – Tire
Sensors” of the SmarTire
®
TPMS Operator's Manual (BW2920).
2. Follow the instructions in “Section C: System Installation – Components and Programming” to install the bracket,
ECU, (warning lamp if used) and harnesses on the vehicle.
2. Follow the “4.1 Configuring & Customizing Your SmarTire Trailer-Link
™
System” section in cases where any
system parameters need to be adjusted.
This page is only a quick set-up guide. For complete installation
instructions,
download the SmarTire Trailer-Link
™
TPMS
Operator's Manual (BW2920)
from the Document Library, or
the Literature Center, at www.bendix.com.
NOTICE
Always replace SmarTire
®
Tire Pressure Monitoring System fuses with (maximum) 5 amp fuses.
Recommended
ECU Locations
NOTE:
This Figure
shows wheel
position P1
as a "1" on the
tire symbol,
and so on.
