Bender UNIMET 300ST, Руководство по эксплуатации

Страница: 21 / 62

Operation and configuration
21 TGH1365en/10.2012
4.5.2 Device type query
Test results are often stored in the PC software. If the device to be tested is to be sorted in the
software according to type, the type name can be entered in the UNIMET when carrying out the test.
In this case, select "Device type query: On". The setting applies until it is changed again.
4.5.3 Warm-up and cool-down period
Once they have been switched on, an increasing number of DUTs need to complete a self-test and
warm-up period, followed by a cool-down period prior to shutting down. Examples include comput-
ers, processor-controlled devices and laser equipment. For these devices, the UNIMET® ST may only
start the measurements once the DUT has warmed up or "booted up". Otherwise, there is a risk that
the parts of the device to be tested will only have switched on partially or not at all, and therefore
will not be tested.
Once the measurements are complete, the UNIMET may only shut down the DUT once it has shut
down or cooled down. Otherwise, on laser equipment, there is the risk of overheating or, on a com-
puter, of sectors of the hard disk becoming unusable.
Select "Warm-up/cool-down period: On".
The settings selected for the "Warm-up/cool-down period" applies to all devices
under test for which the test has been put in operation. The settings remains until
it has been changed again.
Device setting
1.Select “Device type query”
2. The following is asked when saving a test:
"Off" - device ID only
"On" - device ID and device type
1. Exit
2. Device type: Off
Enter device type
before entering ID
1. Exit
2. Test probe calibr.
3. Device type query
4. Warm-up/cool-down
ESC
Device setting
1.Select “Warm-up/cool-down”
2. “Off” - not hot or cooling-off phase
“On” - After switching on the device
under test warm-up phase, before
switching off the device under test
cooling-off phase.
1. Exit
2. Warm-up/cool-down
period: On
1. Exit
2. Test probe calibr.
3. Device type query
4. Warm-up/cool-down
ESC