Bender TM800, Руководство пользователя, Страница: 20 / 92

Installation and connection
20 TM800_D00165_00_M_XXEN/06.2015
Surface-mounting enclosure (AP)
The anodised surface-mounting enclosure is suitable for both pure surface-mounting and for partial-
ly recessed mounting. The enclosures can be supplied with a depth of 90, 150 and 210 mm.
The support frame inside the flush-mounted or surface-mounted case is fitted with a long-term elas-
tic seal in order to avoid the ingress of cleaning agents into the panel. Depending on the size, the
front plate is connected to the flush mounting or surface mounting enclosure by two or more stable
hinges. This guarantees easy installation of the alarm indicator and operator panel.
All necessary modules and display elements are permanently fixed to the front plate using threaded
bolts or mounting frames. The front plate is connected with the mounting plate via a flexible spiral
hose that is fixed on both sides with cable clips. The technical equipment and systems are connected
to a terminal board that is fixed on a mounting plate. The power supply unit for the alarm indicator
and operator panel is also located on this mounting plate. The mounting plate can easily be disman-
tled. That allows the flush-mounting or surface-mounting enclosure to be installed prior to the final
assembly stage. Cable connections between the front plate and the terminal board also do not need
to be disconnected.
With the exception of the mounting plate no other components are fixed to the baseplate of the
flush-mounting/surface-mounting enclosure, allowing sufficient room for installation.
4.1.2 Unpacking
Unpack all the parts supplied with the system. Do not use sharp-edged tools that may damage the
content of the packaging.
Compare your order with our delivery note to check that you have received all products in full. The
article numbers printed on the nameplates simplifies the identification of the devices.
Check all parts supplied for any evidence of damage in transit. Devices damaged
in transit must not be used. If a device is damaged, please contact Bender. Details
of who to contact are indicated on the delivery document.
Before using devices that have been stored at low temperates: Leave the devices
to stand for 3 to 4 hours at room temperature before connecting the power sup-
ply. A change in temperature from cold to warm will result in condensation on all
device components. Putting damp devices into operation risks damaging elec-
trical components and there is a danger of electric shock on contact.
WARNING
WARNING