Bender FTC470XET, Руководство по эксплуатации

Страница: 23 / 84

Installation
23 TGH1375en/02.2010
5.2 Mounting and connection of the device
When the device is connected to a single personal computer, please note that a cross-over-
patch cable is used to carry out work step 4.). Besides a cable and a personal computer no
other components are required.
The following description is based on the assumption that the device is connected to a local
network (LAN).
1. DIN rail mounting
Snap the clamping springs at the rear of the FTC470XET into place in a way that a tight and secure fit
is ensured.
2. Connection to supply voltage U
S
:
Connect the terminals A1 and A2 to a supply voltage of U
S
= 85 to 275 V (AC/DC). A 6 A fuse is recom-
mended for supply voltage protection. In case of connection to an IT system, all poles have to be
protected. In case of DC voltage supply, any connection polarity can be used.
3. Connection to BMS:
Connect the terminals A and B to the BMS bus using the control cable (A to A, B to B). A suitable cable
type is J-Y(St)Y 2x0.6.
If the FTC470XET is located at the end of the bus, the end of the bus must be terminated with a
120
Ω
resistor. For that purpose loosen the terminals A and B in order to connect the terminating
resistor in parallel.
4. Ethernet connection to a local network (hub, switch, router):
Connect the Ethernet connection socket to the respective local network using a straight through-
patch cable (LAN cable). Please observe the data transmission rate of the FTC407XET: 10 Mbit/s.
Connection via a Switch may be necessary.
After completion of your work, please check whether the internal Web server of the FTC470XET can
be accessed by a browser. For this purpose, enter the URL into the address field of the Web browser
(in the example above http://172.16.10.54).
When everything functions normally, the start page of the internal Web server will appear.
5. Then check whether devices connected to the BMS side can be queried.