Bender ATICS Series, Руководство пользователя, Страница: 55 / 104

ATICS-DIO_D00080_03_M_XXEN / 04.2021 55
ATICS-…-DIO
6.2.3.4 Test menu 4: Generator
Executing this function makes sense only when a generator is connected to the redundant line and the
corresponding settings have been carried out (see chapter „Settings menu 1: Changeover“ on p. 67).
To avoid voltage interruptions, in the test menu "Generator", the ATICS® does not switch to the redun-
dant line. In order to test the generator and the changeover switch, select "Autom. changeover" or
"Manual changeover".
Generator Generator start relay is switched. The generator starts. However, there is no
changeover to the redundant line. The test is not terminated and the generator switched off again until
the "RESET" button has been pressed. The display shows the test duration.
Cancel Return to test menu
The messages from this test are also stored in the history memory. The date of the test is saved to send
a reminder for the next test once the test interval has elapsed.
I
r
isk
that the generator test is accidentally not completed.
If the test menu 5: "Generator" is left after the generator has started, the ATICS® remains in this switch
position and in "TEST" mode. This means that the generator is not switched off.
- Wait until "Quit: RESET" appears on the display.
- Press the "RESET" button.
- Check whether the generator is switched off.
6.2.3.5 Test menu 5: Test communication
Communication test via the BMS bus. In order to do this, a fault message is simulated. This alarm mes-
sage is sent to evaluator devices (e.g. alarm indicator and operator panels, MK800, SMO…).
Check that these devices are responding to the alarm message as requested.
Generator
Cancel Generator
Test
t (1->2): 8ms
t (Test): --
Quit: RESET