SpA
BL 30 / 35
5
•
Fill up when the engine is off and not hot, always in an open space far from fires or any heating source and refrain from
smoking during this operation.
•
Before starting the machine make sure that you can quickly stop the engine and that you are familiar with the control levers.
•
Never allow the engine to run in enclosed spaces where the highly toxic carbon monoxide could not evacuate.
•
Never start or use the machine not completely assembled especially concerning the safety devices and the tiller protection
guards which should always be completely assembled with all its extensions.
•
Never fix or clean the tiller blades or any other tools when the engine is running.
•
Attention ! Don’t’ use the machine on sloping grounds exceeding the limit indicated in the use and maintenance booklet of
the engine.
•
We are not responsible for accidents due to the wrong use of the machine neglecting the above basic instructions.
STARTING AND STOPPING THE MACHINE
Starting the engine of the machine always follow these instructions very carefully:
•
Check the oil in the engine : THE BRAND NEW MACHINE IS DELIVERED WITHOUT OIL IN THE ENGINE, THEREFORE
YOU SHOULD FILL IT UP TO THE LEVEL ON THE DIP STICK OF THE OIL CUP.
•
Please check the engine USE AND MAINTENANCE concerning the “operations before staring”.
•
Start the engine only in open spaces.
1.
Pull the choke lever on the engine.
2.
Turn the accelerator lever “F” to the “MAX” position (PICT 8).
3.
The clutch lever “G” should be released in position “a” (PICT 9-10).
4.
Pull the starting rope by the handle “I” smoothly first than strongly: when you feel some resistance don’t leave the handle
but help the recoiling of the rope with your hand (PICT 11).
5.
When the engine runs move the choke lever to the initial position and the accelerator lever in the mid-position (PICT 8).
6.
For stopping the engine move the accelerator lever “F” in “STOP” position.
- PICT n°8- -PICT n°9 - -PICT n°10-
USE AND ADJUSTMENT
•
You can start the rotation of the tiller pulling the clutch lever “G” up to position “b” (PICT 9-10) the machine will immediately stop
releasing the lever.
•
In the model BL35 with two levers you can insert the reverse gear pulling the hand lever “H” in position “b” (PICT 10).
•
In the model BL30 pulling the clutch lever in position “b” the correct space of the internal sides of the belt (PICT 12) s hould be of 45-
55 mm.
•
In the model BL35 this space should be of 60 - 70 mm (PICT. 13). Note that you can check this space only after removing the side
plastic cover through the fixing screws.
-PICT n°11-