Instructions Sheet
www.belson.com
PARTS LIST:
26 - 3 1/2” ZINC PLATED LAG SCREWS
12 - 2 1/2” DECK SCREWS
6 - 2 1/2” LAG SCREWS
1 - #2 PHILLIPS HEAD DRIVER BIT
TOOLS NEEDED FOR INSTALLATION:
VARIABLE SPEED DRILL OR SCREW GUN
7/16 SOCKET OR IMPACT WRENCH
HAMMER OR RUBBER MALLET
INSTALLATION INSTRUCTIONS:
1. CHECK PARTS LIST AND VERIFY ALL PARTS AND HARD-
WARE.
2. ATTACH SEAT/LEG ANCHOR BLOCK TO BOTTOM OF SEAT
SUPPORT USING 3 1/2” LAG SCREWS WITH WASHERS. NEXT
USING 3 1/2” LAG SCREWS WITH WASHERS ATTACH SEAT TO
CENTER SUPPORT MAKING SURE YOU ANCHOR INTO
PRE-DRILLED DIVETS.
3. ON A FLAT SURFACE AND USING 12 1/2” DECK SCREWS
START THE SEAT ASSEMBLY. IT IS IMPORTANT THAT THE
SEATS BE ASSEMBLED IN THE ORDER DETAILED BELOW.
ALIGN THE SEATS AS SHOWN IN DIAGRAM. AFTER ALIGN-
MENT, SCREW
( 2 ) 2 1/2” DECK SCREWS INTO EACH POSITION LABELED A
ON THE DIAGRAM. PUT ALL SCREWS INTO POSITIONS A.
THEN SCREW ( 2 ) 2 1/2” DECK SCREWS INTO EACH POSI-
TION LABELED B ON THE DIAGRAM. DO NOT SCREW INTO
POSITION B FIRST. IF POSITION B IS SCREWED INI FIRST, A
HEX TABLE HARDWARE
SEAT AND ANCHOR BOARDS
HEX TABLE LEGS
HEX TABLE TOP ASSEMBLY
627 Amersale Drive
Naperville, IL 60563
Phone: (800) 323-5664
Fax: (630) 897-0573