Belmont PROIII 047, Инструкция по эксплуатации, Страница: 23 / 36

23
Changing Treatment Position and Entry/Exit Position Changing Treatment Position and Entry/Exit Position
You can alter the default of the Treatment Position and/or Entry/Exit
Position by the following manner:
1 Set the seat and the backrest to the desired treatment position or
entry/exit position by manual mode stick switch.
2 Press and hold the automatic mode stick switch to the desired
position side until buzzer sounds (in about 5 seconds), then release
it.
The position is memorized.
Set to treatment 1 position: Push down to left
Set to treatment 2 position: Push down to right
Set to treatment 3 position: Push down to up
Set to entry/exit position : Push down to down
3 After moving the chair position once, press the stick switch in the
direction you have just set to confirm the newly memorized setup
will function.
During automatic movement (Preset, Automatic return and Last
position memory), by pressing any side of the stick switches the
automatic movement will be cancelled immediately. (An electronic
beep is emitted when the operation is stopped (cancelled).)
Legrest raising angle and rollup extension are automatically controlled
by backrest angle in automatic operation only.
You can’t manually raise legrest nor use rollup extension.
Canceling an Operation
Positional Relation Between Backrest Position and Legrest
Movement/Rollup Extension
Up tilt Limit position
Lay flat
Limit position
4
3
2
1
At the range 3&4
of backrest angle
the rollup extends
When the backrest angle is in:
Range 4
Range 3
Range 2
Range 1
Moving the Chair to Preset Positions (Automatic Operation)