9-3. Inserting a new bulb
Replace halogen lamp only with type JA-24V 60W cbtaainable through your local dealer.
IMPORTANT
(1) At inserting the bulb, make sure that the projection of the bulb holder and the cut-out of the bulb are
aligned. Misalignment will cause an improper light pattern.
(2) Close the bulb retaining spring. Make sure to place the springs behind the hook. See Fig.9-3-2
(3) Firmly attach wire connectors. See Fig.9-3-3
-9-
9-4. Attaching the reflector cover
(1) Insert the cut-out of the reflector cover into the gap at the handle (right). See Fig.9-4-1
(2) Be careful not to pinch the wires when attaching cover. See Fig.9-4-2
(3) Hold the reflector cover and tighten the screw by turning it clockwise by 90 degrees.
Make sure to tighten it by pushing it forward until it clicks. See Fig.9-4-3
Connect firmly
Cut-out of bulb
Projection
of the bulb holder
Light bulb cover fixing screw
Cut out
Reflector cover
fixing gap
Light bulb cover fixing screw
Thread hole
* Push and tighten
until it clicks
Be careful not to pinch the wires
Fig.9-3-1
Fig.9-3-2
Fig.9-3-3
Fig.9-4-1
Fig.9-4-2
Fig.9-4-3