Belmont CP-ONE PLUS, Руководство по эксплуатации, Страница: 45 / 96

Unit part
41
Foot controller

Sensor type foot controller

Pedal
▪ The rotational speed of the turbine and output of
the air scaler may be adjusted by the degree of
stepping on the pedal.
▪ The rotational speed of the motor may be
adjusted by the sliding position and degree of
stepping on the pedal. The rotational speed when
stepping on the pedal may be increased if the
pedal is slid counterclockwise in advance. The
rotational speed when stepping on the pedal
according to the sliding position is shown on the
indicator.
▪ The output of the electric scaler may also be
adjusted by the sliding position of the pedal. The
output activated when stepping on the pedal may
be increased if the pedal is slid counterclockwise
in advance. Output cannot be adjusted when
output is activated. When the pedal is slid
(rotated) while stepping on it, stop stepping to
turn off output once and step on the pedal again
to restart.

Coolant switch
▪ Spray can be turned on and off by stepping on the
coolant switch like the membrane switch of the
table.
▪ Four mode operations (turning on and off
spraying, water only and air only) may be
selected.

Chip blow switch
▪ Chip air may be blown out to blow out cutting
chips, etc., from the handpiece by stepping on the
chip blow switch.
NOTICE
* The mark on the pedal shows the center of the pedal. It merely shows the standard. It does not mean
that the scaler output is the central value.
When a leak or spill has occurred, such as water, wipe the floor immideately.
Coolant switch
Turn clockwise to decrease.
Pedal
Turn counterclockwise to
increase.
Chip blow switch
OPERATING INSTRUCTIONS