Belling IDW604MK2, Инструкция по эксплуатации

Страница: 24 / 30

6
4
5
7
2
RU BBER
SCREW
COVER
8
SCREW
CONE GEAR
6B
6A
【 】
Figure 7
Dishwasher installation steps ●
.
.
.
.
6
8
9
1 Install the furniture door to the outer door of the dishwasher using the brackets
provided. Refer to the template for positioning of the brackets.
2 Adjust the tension of the door springs by using an Allen key turning in a clockwise
motion totighten the left and right door springs. Failure to do this could cause damage
to your dishwasher (Illustration 2)
3 Connect the inlet hose to the cold water supply
4 Connect the drain hose. Refer to diagram (Figure 6)
5 Connect the power cord
Put the dishwasher to slide rails(Illustration4)
7 Affix the condensation strip under the work surface of cabinet. Please ensure
the condensation strip is flush with edge of work surface.
Place the dishwasher into position.
Level the dishwasher. The rear feet can be adjusted from the front of the dishwasher
by turning the screws on the left and right hand side of the cabinet (Illustration 6A).
To adjust the front feet, use a wrench and turn the front feet until the dishwasher is level
(Illustration 6B).
10 The dishwasher must be secured in place. There are two ways to do this:
A. Normal work surface-secure to the work surface by using two woodscrews ensuring
the dishwasher weight is not being hit by the surface (Illustration 7).
B. Marble or granite work top-secure the bracket to the side panel of the dishwasher
and secure the dishwasher to the furniture housing. Put the rubber cap over the screw
(Illustration 8).
.