Belling IDW450MK2, Инструкция по эксплуатации

Страница: 27 / 32

Positioning the Appliance
How to Drain Excess Water From Hoses
If the sink is 1000 higher from the floor, the exces s water in hoses cannot be drained di rectly
into the sink. It will b e necessary to d rain excess water from hoses into a bowl or suitable
container that is held outside and lower than the sink.
The following things should be checked before starting the dishwasher.
The content of this manual is very helpful to the users.
After installation, please make sure to keep this manual.
Extension Hose
If you n eed a drain hose extensi on, make sure to use a similar dra in ho se.
It m ust be no longer than 4 metres; o therwise the cleanin g effect o f the dishwasher could b e re duced.
1 The dishwasher is level and fixed properly
2 The inlet valve is open
3 There is a leakage at the connections of the conducts
4 The wires are tightly connected
5 The power is switched on
6 The inlet and drain hoses are knotted
7 All packing materials and printings should be taken out from the dishwasher
Connect the cold water supply hose to a threaded 3/4(inch) connector and make
sure that it is fastened tightly in place.
If the water pipes are new or have not been used for an extended period of time,
let the water run to make sure that the water is clear. This precaution is needed
to avoid the risk of the water inlet to be blocked and damage the appliance.
Position the appliance in the desired location. The back should rest against the wall behind it, and the sides,
along the adjacent cabinets or walls. The dishwasher is equipped with water supply and drain hoses that can
be positioned either to the right or the left sides to facilitate pro per installation.
Water Outlet
Connect the wa ter drain hose. The drain hose mu st be correctly f itted to avoid water leaks.
En sure that the wat er drain hose is not kinked or squashe d.
Syphon Connection
The waste connection must be at a heigh t of betw een 40 cm (minimum) an d 100 cm (maximum)
fro m the bottom of t he dish. The water drain hose should b e fi xed by a hose clip. The free end of
the hose must not be immersed in water.
Please close the hydrant after using.