IF HEAT AND CONVEYOR DO NOT WORK, ALLOW UNIT TO COOL FOR
30 MINUTES. PRESS THE RESET BUTTON LOCATED AT THE BACK OF
THE CONTROL BOX BENEATH THE TOASTER.
BEFORE PRESSING RESET BUTTON, MAKE SURE AIR INTAKE (COOLING FAN)
IS CLEAN AND FREE OF DUST AND GREASE BUILD UP.
CONTROL BOX
RESET BUTTON
TOAST CHUTE
FRONT
OF TOASTER
BACK
OF TOASTER
COOLING FAN
PAGE 3
OPERATIONS AND MAINTENANCE PROCEDURES
CONVEYOR TOASTER MODELS
JT2-B
CLEANING PROCEDURE
Preventive Maintenance programs on your toaster will provide many years of production at full
capacity. Lack of Preventive Maintenance can shorten the life cycle of the toaster and/or result in
reduced capacities. The following cleaning guidelines should be performed as shown:
WARNING – ALWAYS DISCONNECT YOUR TOASTER FROM POWER
PRIOR
TO CLEANING OR MAINTENANCE
WARNING –
NEVER
SPRAY YOUR TOASTER WITH WATER.
NEVER
SUBMERGE INTO WATER.
Daily – 1) Clean the air intake area under the toaster with a slightly dampened cloth.
2) Wipe the conveyor surface and exterior surfaces.
3) Remove and wash the Crumb Tray and then replace the Crumb Tray.
Weekly - 1) Clean the air intake area under the toaster with a slightly dampened cloth.
2) Plug the toaster in and turn the bottom switch to the ON position.
3) Turn the Conveyor Speed Control to fastest setting (100).
a. For lightly soiled conveyors belts, wipe with a damp cloth.
b. For heavily soiled conveyor belts, wipe with a light abrasive pad.
NEVER OPERATE YOUR TOASTER WITHOUT THE CRUMB TRAY IN PLACE
AS THIS MAY CAUSE OVERHEATING IN AND AROUND THE CONTROLS AND
MOTORS.
HIGH TEMPERATURE LIMIT
JT2-B Toasters are equipped with a special feature that prevents overheating. This feature is re-
settable by pushing the button located at the back of the control housing (opposite panel from the
front controls). Reach under the toaster and slide your hand to the rear of the bottom panel and
then up to the back of the housing. Feel around to the center of that back panel and you will find
the reset button. Push it and re-test your toaster.
