Belle PRO TROWEL 1200, Руководство оператора

Страница: 27 / 262

27
Warranty
Your new Altrad Belle Pro Trowel is warranted to the original purchaser for a period of one-year (12 months) from the original date of
purchase.
The Altrad Belle warranty is against defects in design, materials and workmanship.
The following are not covered under the Altrad Belle warranty:
1. Damage caused by abuse, misuse, dropping or other similar damage caused by or as a result of failure to follow assembly,
operation or user maintenance instructions.
2. Alterations, additions or repairs carried out by persons other than Altrad Belle or their recognized agents.
3. Transportation or shipment costs to and from Altrad Belle or their recognized agents, for repair or assessment against a warranty
claim, on any machine
4. Materials and/or labor costs to renew, repair or replace components due to fair wear and tear.
The following components are not covered by warranty.
· Drive belt
· Engine air ¿ lter
· Engine spark plug
Altrad Belle and/or their recognized agents, directors, employees or insurers will not be held liable for consequential or other
damages, losses or expenses in connection with or by reason of or the inability to use the machine for any purpose.
Warranty Claims
All warranty claims should ¿ rstly be directed to Altrad Belle, either by telephone, by Fax, or in writing.
Tel: +1 540.345.5090 Fax: +1 540.345.5091
Email : Sales@bellegroup.net
Write to:
Altrad Belle Inc.
3959 Electric Road,
Roanoke, Suite 360,
VA 24018
USA
Troubleshooting Guide
Problem Cause Remedy
Engine will not start. No fuel. Open fuel tap.
Fill fuel tank .
Engine switched off. Switch engine on.
Spark plug fouled. Clean and reset plug gap.
Engine cold. Close choke.
Engine À ooded. Open choke, fully open throttle, pull recoil starter until engine
¿ res.
Cutout Switch in OFF position. Move Cutout Switch to ON position.
Leaving Swirls in Concrete.
Rolling Concrete.
Bouncing.
If some of the above mentioned problems occur, please check the following:
Main Shaft When the machine has a rolling motion, check the main
shaft of the gearbox.
Spider Plate Check Spider plate for bent trowel arms. If one is bent
replace it.
Blades Check the adjustment on trowel arms at adjustment lever, and
ensure all trowel arms are adjusted equally.
Blades should be of the same measurement / dimension and
designed to ¿ t the machine.
Excessively worn blades should not be used.