BEU SYSTEM PRACTICES
AT
&
TCo Standard
SECTION 503-200-102
Issue 1, June 1977
TELEPHONE SETS
902A 1 AND 2902A 1
1.
GENERAL
1.01
This section provides identification, installation,
and connection information for the 902Al
(Fig. 1) and 2902Al DESIGN LINE* telephone
(Sculptura)
sets.
* Trademark AT&TCo.
1.02
Whenever this section is reissued, the reason
for reissue will be listed in this paragraph.
1.03
The customer's premises must be properly
wired with an appropriate connecting block
or jack in order to accept the D4BU-29 plug-ended
mounting cord or 225A adapter furnished with each
telephone set.
Warning:
Telephone apparatus or
wiring shall not be installed in a
location where minimum separation
from other wiring as specified in
Section
460-300-149
c a n n o t b e
maintained.
2.
IDENTIFICATION
2.01
The 902Al (rotary dial) and 2902Al
(TOUCH-TONE® dial) equipped telephone
sets are new DESIGN LINE telephone sets being
made available to the customer.
The customer
buys the housing and handset from the telephone
company and the telephone company retains
ownership of the transmission and signaling
components.
2.02
Refer to Table A for available codes and
ordering information.
2.03
These telephone sets are intended to be
used as single line or two-party desk sets
and are not recommended for use on four- and
eight-party service.
Fig. 1-2902A 1 Telephone Set
2.04
Op t i o n a l Co m p o n e n t (o r de r e d
separately):
•
819040122 (P-90D012) Guard Assembly.
3.
INSTAllATION AND CONNECTIONS
3.01
These telephone sets are furnished from
the factory fully assembled and wired for
bridged ringing. The PIA ringer is shipped from
the factory with the bias spring in the low bias
position. To connect the telephone set, plug the
mounting cord into a 625-type connecting block or
if the existing jack is a 548A or equivalent, use
the 225A adapter furnished with each set.
3.02
The internal connections for the 902Al and
2902Al telephone sets, for nonkey system
use, are shown in Fig.
3
and 4, respectively.
3.03
Connections for lA KTS do not require any
set modifications and are the same as Fig.
3
and 4.
NOTICE
Not for use or disclosure outside the
Bell System except under written agreement
Printed in U.S.A.
BSP S03-200-102-i01_1977-06-0l.jpg Scanned by Frank Harrell, (Cowboy Frank) Castle Rock, Colorado Feb 08,2012 18:18:42
Page 1
