Belden Miranda KMV-3901, Быстрый старт

Страница: 14 / 27

10
Setting Up Your Multiviewer
Changing the Multiviewer’s IP Address from the Densité Control Panel
The Status LED on the selected card flashes orange, and the associated control menu
appears on the display of the Densité frame’s local control panel.
2 On the local control panel, press the [–] button repeatedly until NETWORK SETTINGS
appears on the display, and then press the SEL button:
IP ADDRESS EDIT appears on the control panel’s display.
3 Press the SEL button again.
The current IP address appears on the display.
• Press the [+] and [–] buttons, to change the current value at the current input
position.
• Press SEL to move one position to the right.
Note:
You can navigate the control menu by using the four buttons located
beneath the display:
• Press the [+] and [–] buttons, to navigate between menu options or
between parameter values.
• Press SEL to access the next menu level. When a parameter value is shown
on the display, modify the value by using the [+] and [–] buttons, and then
press SEL to apply the new value.
• Press ESC to go back to the previous menu level.
• Once you have completed your changes, press the Select button
on the
front edge of the KMV-3901/3911 card to exit the control menu.
Select button
Status LED
Boot LED,
Power LED,
CPU Status LED (other side of board)
SDI LEDs
USB connector (other side of board)