Belden Miranda KMV-3901, Быстрый старт

Страница: 13 / 27

9
KMV-3901/3911
Quick Start Guide
Changing the Multiviewer’s IP Address from the Densité Control Panel
Verifying the Densité Controller’s Restore-Point Settings
The Densité CPU-ETH2 controller can keep a restore point for some or all cards in the
Densité frame. The controller’s configuration includes a
default action that determines what
happens when a card is inserted or restarted. If the default action is set to update card
settings then, if a restore point for the same model of Densité card is found on the controller
card, the controller will automatically apply all parameters from the restore point to the
Densité card. In the case of a KMV-3901/3911 card, this would prevent you from changing
the card’s network settings. To do so, you would need to momentarily set the default action
to
keep card settings .
To verify the restore-point settings, and adjust the default action if needed
1 On the Densité frame’s local control panel, press the CONTROLLER button.
2 Press the [–] button repeatedly until RESTORE POINTS appears on the display, and then
press the SEL button.
3 Press the [–] button repeatedly until DEFAULT ACTION appears on the display, and then
press the SEL button.
• If the control panel’s display shows KEEP SETTINGS, then the controller
configuration will not prevent you from changing your KMV-3901/3911 card’s IP
address.
• If the control panel’s display shows UPDATE SETTINGS, navigate to KEEP SETTINGS
by pressing the [+] button, and then press the SEL button to apply your change.
4 Press the CONTROLLER button to exit the controller’s menu.
Changing the Multiviewer’s IP Address
To change the IP address of a KMV-3901/3911 multiviewer card
1 Press the Select button on the front edge of the KMV-3901/3911 card.
IMPORTANT
Before changing a KMV-3901/3911 multiviewer’s IP address, you must first
make sure that the Densité controller’s restore-point settings will not
prevent you from doing so, and momentarily adjust the controller’s settings
if needed.