Belden Miranda DENSITE 3+ FR1, Руководство пользователя

Страница: 18 / 65

4
Densité 3+ FR1 Housing Frame
Installation
• Right side - a second power supply is located on the lower right, and above it is a single
slot reserved for System Cards.
Note: This slot supports ONLY designated System Cards; do not insert any other cards.
At the time of writing, only the REF-1801-FR1 or the GPI-1501 card is supported.
• If the system card slot is occupied by a REF-1801-FR1 card and you need a GPI-1501
card in your frame, you can install one in one of the four standard slots using a 3RU
adapter.
• For an up-to-date list of available System Cards, go to the Grass Valley website at
www.grassvalley.com
When the frame door is closed, the status LED on each of the cards in the frame is visible via
a light pipe in the door. No other controls or indicators are present.
Rear of the Frame
The rear of the Densité 3+ FR1 frame is visually divided into three sections:
• Right side - this area contains inputs and outputs for the Controller Card - the Fan
Speed control setting switch, the GPI port and the two Ethernet ports. It also contains
the power socket for the power supply located beneath the controller card, and one of
the two frame fans.
• Center - this area holds the rear panels associated with the frame’s four Densité-3 slots
• Left side - this area contains the rear panel for the System Card, the power socket for
the power supply located beneath the System Card, and one of the two frame fans.
Installation
Unpacking
Make sure the following items have been shipped with your Densité 3+ FR1 frame:
• Densité 3+ FR1 frame, including 1 Power Supply unit (AC in) with power cord