Belden KMX-4911, Быстрый старт

Страница: 15 / 25

9
KMX-4911
Quick Start Guide
Step 2: Networking Setup
For the KMX-4911 multiviewer to join a TCP/IP network, it must be configured with a system
IP address, a network mask, a gateway, and a system name. In addition, a client PC must be
configured to communicate with the multiviewer (see
Configuring a Client PC , on page 13).
You must also configure any Kaleido-RCP2 units you may have ordered.
The KMX-4911 is shipped with the following default settings:
Changing the Multiviewer’s IP Address
To change the IP address of a KMX-4911 multiviewer
1 Press the Select button on the front edge of a KMX-4911 card that belongs to the
system you wish to configure.
• If you changed a parameter from the card’s control menu, but have not
applied your change (you did not touch the SEL button on the local control
panel), once the 30-second timeout has occurred, the parameters will be
confirmed as if you had touched the SEL button.
Notes (continued)
System IP address 192.168.3.30
Network mask 255.255.255.0
Gateway 0.0.0.0
Note:
If the system IP address of the multiviewer has been changed (i.e. it no
longer corresponds to the as-shipped configuration), it is still possible to
determine the current setting. To determine the IP address of your KMX-4911
multiviewer, see
Finding the System IP Address and Application Version , on
page 11.
Select button
Status LED