Belden HIRSCHMANN RSP20, Руководство пользователя

Страница: 39 / 70

Installation RSP20/25/30/35
Release 18 09/2021
39
2.4 Installing an SFP transceiver (optional)
Prerequisites:
Exclusively use Hirschmann SFP transceivers.
See “Accessories” on page 66.
Figure 3: Installing SFP transceivers: Installation sequence
Proceed as follows:

Take the SFP transceiver out of the transport packaging (1).

Remove the protection cap from the SFP transceiver (2).

Push the SFP transceiver with the lock closed into the slot until it latches
in (3).
2.5 Connecting the terminal blocks
Note: The supply voltage is connected to the device casing through
protective elements exclusively.
WARNING
ELECTRIC SHOCK
Before connecting the electrical wires, always verify that the requirements
listed are complied with.
See “Requirements for connecting electrical wires” on page 9.
Never insert sharp objects (small screwdrivers, wires, etc.) into the
connection terminals for electric conductors, and do not touch the terminals.
Failure to follow this instruction can result in death, serious injury, or
equipment damage.
3