Belden Hirschmann RS20 U Series, Руководство пользователя

Страница: 30 / 48

30
Installation RS20/RS30-...U
Release 03 08/2019
Proceed as follows:

Remove the protective cap from the SFP transceiver.

Push the SFP transceiver with the lock closed into the slot until it latches
in.
2.5 Adjust DIP switch settings
The 2-pin DIP switch on the front panel of the device gives you the following
options:
Figure 11: 2-pin DIP switch
Note: DIP switch “SW2” is not being used, so the switch setting has no effect.
State on delivery: both DIP switches “OFF”.
No ports have been learned, and link monitoring is disabled on the ports.

Before starting operation of the device, check whether the default settings
of the DIP switch correspond to your requirements.
LAlearn switch
Position Learn ports Link monitoring
ON on on
OFF off off
LA learn
SW2
ON